Domesticelectrical services
Rewiring, lighting, safety checks, repairs and new installations for homeowners, landlords and anyone renovating, extending or building a home in Lanarkshire and Glasgow.
Fully qualified & insured
Or call07813 622219
Covering North Lanarkshire, South Lanarkshire and Glasgow
Call07813 622219WhatsAppMessage usGet a quoteRewiring, lighting, safety checks, repairs and new installations for homeowners, landlords and anyone renovating, extending or building a home in Lanarkshire and Glasgow.
Fully qualified & insured
Or call07813 622219
The wiring and protection behind everything else, for older homes, renovations, extensions and new builds.
New wiring for houses and flats, throughout or just for the rooms and circuits that need it. Often recommended for older homes with rubber or fabric-insulated cable, and the right time to plan sockets and lighting for a renovation or extension.
Replacing an old fuse box with a modern consumer unit with RCD (residual current device) protection, which cuts the supply quickly if current leaks to earth. Worth doing if you still have rewireable fuses, a board that trips often, or a recommendation on an EICR.
A dedicated circuit for a hot tub, home office, workshop or high-powered appliance. Your existing installation is checked first to make sure it can take the extra load.
The complete installation for a new home. First fix runs cables and fits back boxes before the walls are boarded; second fix fits sockets, switches, lights and the consumer unit, and the installation is then tested.
Power where you use it, and lighting that suits each room, inside and out.
Extra sockets where you need them, USB sockets, dimmer switches, and moving sockets or switches to more useful positions. Damaged or scorched accessories can be replaced at the same time.
LED downlights, pendants, spotlights and under-cabinet lighting, with switching planned around how each room is used.
Garden and wall lighting, weatherproof sockets, and power to garages, sheds and summerhouses, with cables protected for outdoor use.
The rooms where appliances, layout and safety rules matter most. We can work alongside your kitchen or bathroom fitter.
Connections for cookers, ovens, induction hobs and extractors. An induction hob or range cooker often needs a higher-rated circuit than the appliance it replaces, so the supply is checked before anything is connected.
Electric showers, extractor fans, illuminated mirrors and lighting. Bathrooms have specific rules about what can go in each zone around a bath or shower, and an electric shower needs its own suitably sized circuit.
Describe the problem or the work you have in mind, and we’ll explain what’s involved.
Or call07813 622219
Checking the condition of your installation, meeting the requirements in Scotland, and putting things right when something goes wrong.
An Electrical Installation Condition Report (EICR) checks the fixed wiring and lists any defects by urgency, which is useful when buying, selling or living in an older home. Private landlords in Scotland need an electrical safety check (an EICR plus testing of the appliances they supply) before a tenancy starts and at least every five years. We can also carry out the remedial work a report identifies.
Hardwired, interlinked alarms to the Scottish standard: a smoke alarm in the living room and in every hallway and landing, and a heat alarm in the kitchen. A carbon monoxide alarm is also needed where there is a boiler, open fire, other carbon-fuelled appliance or a flue.
Bringing the main earthing and the bonding to gas and water pipes up to standard so faults clear safely, and fitting surge protection at the consumer unit. Often flagged on an EICR or done alongside a consumer unit upgrade.
Tracing and fixing tripping circuits, faulty sockets, flickering lights and loss of power to part of the house. If the whole street has lost power, the fault is on the network: call the national power cut number, 105.
Electric heating, smart controls and car charging, wired to suit your home’s supply.
Panel heaters, storage heaters and electric underfloor heating, installed with the circuits and controls they need. A practical option for homes without mains gas, or for warm floors in a kitchen or bathroom.
Smart lighting, switches and thermostats, wired in so they work reliably with your installation and heating system.
A wall-mounted charger on its own circuit close to where you park, after checking your supply, consumer unit and earthing. We also replace older or faulty chargers.
Generating and storing some of your own electricity, and connecting low-carbon heating safely.
Roof-mounted solar PV (photovoltaic) panels turn daylight into electricity, and an inverter converts it for use in the home. A battery stores surplus generation, or electricity bought on a cheaper off-peak tariff, for later in the day, and can be added to an existing solar system.
A dedicated circuit, local isolation and connections for an air source heat pump, after checking your installation can take the extra load. We work alongside the heating engineer who fits the heat pump itself.
Industry guidance generally recommends an inspection at least every ten years for an owner-occupied home, and when a property changes hands. Privately rented homes in Scotland need an electrical safety check at least every five years. The inspector may recommend a shorter interval depending on the condition of the installation.
The report lists any defects with a code. C1 means danger is present, C2 means potentially dangerous, and FI means further investigation is needed; any of these makes the report unsatisfactory. C3 is an improvement that is recommended but not required. We can quote for the remedial work so the installation can be re-tested.
A full rewire usually involves lifting some floorboards and cutting channels in walls and ceilings for the new cables, so it is easiest when a home is empty or already being renovated. Plastering and decoration are normally needed afterwards. We can talk through how the work could be phased around your home.
Yes. Consumer unit is the current name for the board where your circuits are protected. Older boards often use rewireable fuses, while modern units use circuit breakers and RCDs.
Both need their own circuit sized for the load. Whether anything else needs upgrading, such as the consumer unit or the cable to an outbuilding, depends on your installation, so it is checked before the work is quoted.
Say what you need, where the property is and roughly when. For a fault or an upgrade, a photo of your consumer unit is a useful start.